Member Page: Andy Martin

Andy Sherry Andy Martin

Andy Martin

Member ID: Andy-Sherry
Status: Gold Member Gold Member
Portland, OR, USA   USA
Member Since: 2010-03-19
Home Site: The Triumph Experience
Last Login: 2018-06-22 08:06
Forum Activity: 2018-06-22 15:27
Forum Posts: 8,995
Top Contributor

Upcoming Events

I will be at these upcoming events and shows:
No events found.

Personal Vehicle Registry

No vehicles listed in the Registry.

Member Journal – Andy&sherry's Journal

There are 2 total entries in this Journal.

Weber Down Draft Crankcase Venting

Posted on: Saturday March 21, 2015

Manifold port

I drilled and tapped a port in the manifold,i built a device(Gizmo) copied from Paul Tegler's site,i drilled and tapped a port in the fuel pump blanking plate,ran a hose from the blanking plate to the air filter. I got an off the shelf PCV valve from Auto Zone. The Gizmo attaches to the aluminium valve cover and the PCV valve is between Gizmo and manifold port. This set up was trial number one,and had no oil coming out of anywhere other than my 2 small drips underneath which have always bee...

Upgrade Of Wheel Studs

Posted on: Saturday May 24, 2014

old and new studs before machining

i spent the last few days swapping the original stock studs for TR6 rear wheel studs. I was fortunate to bump into someone who works at a machine shop who was able to machine the heads to the same specs as the stock ones. Once they were machined the rear dropped straight in and with advice from the guys here I loosened the hat bolts on the front and put the studs in . Hooked everything back up bled the brakes and tightened the new lug nuts and went for a drive. Its good to know the bigger st...

Triumph Exp Library Articles

No tech articles written by this member.

Join The Club

Sign in to ask questions, share photos, and access all website features

Your Cars

1974 Triumph TR6

Text Size

Larger Smaller
Reset Save

Sponsor Links