Had a couple of hours to work in the cold garage today.
I was able to line up and install (loosely) 8 of the bolts that attach the body to the frame. There is a slight issue on the right front hole below the firewall that I may have to do a slight relief on to get the bolt to catch the threads. I'm not satisfied yet that a little more giggling will get it to align. The bolts above the rear spring and behind the kick panel are in and the holes in the trunk area are aligned well and the Outer bolts that go through the crossmember that is in front of the seat are in. The inner ones line up too, just haven put them in. I'm using copper never seize to make sure they never corrode in place.
I'm away for a few days and will hit it again over the weekend.
Bolts lined up and in loosely
These bolts went in easily
These bolts on the crossmember are aligned well
This one lined up well but the one on the other side may need a little relief (1/8") to allow the bolt to go in