TRExp

Spitfires List Archive

[TR] a rough week for cars

Moss Motors
AutoShrine Sponsor
AutoShrine Sponsor
AutoShrine Sponsor
AutoShrine Sponsor

mailbot Avatar
mailbot Mail List Archive Bot
The Interwebs, USA   USA
This read-only message was archived from a public mail list.
Mail From: "Joe Curry" <(email redacted)>

Jim, If you are fortunate it might only be the throwout bearing.

Joe

-----Original Message-----
From: (email redacted)
[mailto:(email redacted)] On Behalf Of Jim Muller
Sent: Wednesday, June 09, 2010 4:06 PM
To: (email redacted); (email redacted)
Subject: [TR] a rough week for cars

We've been fighting a locking rear brake on the Caravan for months.
Once it got so hot so quickly it blew the tire. It's been diagnosed
as just an over-tight brake, a malfunctioning parking brake, a
malfunctioning self-adjusting mechanism. Lots of parts have been
replaced. They just hired a new certified master mechanic and he
finally diagnosed it as a bad hose, much like us LBC guys have to
worry about. Apparently he pressure-tested it. Only trouble is, the
part is a single hose running form the front to both back wheels, it
cost over $400, they have to pull the gas tank out to install it, and
oh by the way the nearest one is 3 days away.

So for the past two days I've driven the GT6 to work, 110 miles round
trip. Today as I'm sitting in traffic through town only a quarter of
a mile from home I start hearing a horrible grinding, crunching,
rubbing sound. If the tranny is in neutral and I depress the clutch,
it stops. If I release the clutch with the tranny in neutral, it
starts up. When the car is rolling, if I depress the clutch and put
it in neutral the noise stops. If I depress the clutch and put it in
any gear, the noise starts up. The common element in these
combinations is the laygear. Spin the laygear and it ain't happy.
After that wonderful trip to Mt. Desert and two day trips to work, it
decided to get sick so close to home. St. Lucas must have been
looking out for me. But now I have to tear the tranny down again.
Oh well, it's been whining a lot lately anyway.

So I'm down to only one car. The Spitfire has been sitting in the
garage, battery slowly going down and already in negative numbers.
It needed inspection last October. However with a starter battery
attached he fired right up. Maybe tomorrow I can get it inspected
early in the morning then go to work.

Anybody got a spare free month they can lend me?

--
Jim Muller
(email redacted)
'80 Spitfire, '70 GT6+

_______________________________________________
(email redacted)
Donate: team.net/donate.html
Suggested annual donation $11.47
Archive: team.net/archive
Forums: team.net/forums
Unsubscribe: autox.team.net/mailman/options/triumphs/(email redacted)
_______________________________________________

(email redacted)
Donate: team.net/donate.html
Suggested annual donation $11.47
Archive: team.net/archive
Forums: team.net/forums


. Hide banner ads & support this website by becoming a > Gold Supporting Member <
mailbot Avatar
mailbot Mail List Archive Bot
The Interwebs, USA   USA
This read-only message was archived from a public mail list.
Mail From: "Jim Muller" <(email redacted)>

On 9 Jun 2010 at 16:33, Joe Curry wrote:

> Jim, If you are fortunate it might only be the throwout bearing.

Joe, don't I wish you were right. But the TO bearing would stop
making noise, not start, when I release the clutch. And with the
clutch depressed and the car rolling it wouldn't start making noise
whenever I engage any gear, and stop when I put it back into neutral.

--
Jim Muller
(email redacted)
'80 Spitfire, '70 GT6+
_______________________________________________

(email redacted)
Donate: team.net/donate.html
Suggested annual donation $11.47
Archive: team.net/archive
Forums: team.net/forums


mailbot Avatar
mailbot Mail List Archive Bot
The Interwebs, USA   USA
This read-only message was archived from a public mail list.
Mail From: "Joe Curry" <(email redacted)>

Not necessarily. If the bearing is loose the vibrations might cause noise
that is stopped when the bearing contacts the pressure plate fingers. But
in most situations, you are probably right.

Joe

-----Original Message-----
From: (email redacted)
[mailto:(email redacted)] On Behalf Of Jim Muller
Sent: Wednesday, June 09, 2010 6:18 PM
To: (email redacted); (email redacted)
Subject: Re: [TR] a rough week for cars

On 9 Jun 2010 at 16:33, Joe Curry wrote:

> Jim, If you are fortunate it might only be the throwout bearing.

Joe, don't I wish you were right. But the TO bearing would stop
making noise, not start, when I release the clutch. And with the
clutch depressed and the car rolling it wouldn't start making noise
whenever I engage any gear, and stop when I put it back into neutral.

--
Jim Muller
(email redacted)
'80 Spitfire, '70 GT6+

_______________________________________________
(email redacted)
Donate: team.net/donate.html
Suggested annual donation $11.47
Archive: team.net/archive
Forums: team.net/forums
Unsubscribe: autox.team.net/mailman/options/triumphs/(email redacted)
_______________________________________________

(email redacted)
Donate: team.net/donate.html
Suggested annual donation $11.47
Archive: team.net/archive
Forums: team.net/forums


. Hide banner ads & support this website by becoming a > Gold Supporting Member <
. Hide banner ads & support this website by becoming a > Gold Supporting Member <

Sorry, you can't reply to this topic. It has been closed.


Having trouble posting or changing forum settings?
Read the Forum Help (FAQ) or contact the webmaster





Join The Club

Sign in to ask questions, share photos, and access all website features

Your Cars

1974 Triumph Spitfire 1500

Text Size

Larger Smaller
Reset Save

Sponsor Links